Search results

After updating to the Nougat GPS it stopped working. Sometimes it took more than half an hour to sync. Sometimes it arrived at the destination without the GPS fix.

I tested it last night and this morning. It took a few minutes to sync, but it worked fine.

I'm from Brazil. I installed this rom a bit, and have not yet used the gps in traffic. But here in the office the GPS set in minutes, even indoors

GPS Ok. Finally fixed

Waiting anxiously for the update. I use GPS a lot and with Nougat the synchronization takes longer than half an hour

Hello everyone After a week stuck at 50% today unlocked normally. I did not have to request the sms.

Não vai bloquear depois de cada nova atualização no nougat 7 .... apenas uma vez de 5,1 para 7 .... eu recebi sms de verificação de desbloqueio após 3- 4 dias, e no mesmo dia 20hours depois de obter sms xiaomi, eu desbloqueado, e eu instalei twrp 3.03-0 e supersu .. estou tudo atualizado...

Here's the same with google now. GPS got really bad too. Thinking back to 5.1

Hello. Were you able to solve the problem? I replaced the screen of a MI4 WCDMA from a friend and the device ran out of service. I put the SIMcard but does not connect to the network.

with me the GPS on and off alone all the time.

Hello. It has as access the fastoboot in V6 rom? Power + volume down :0)

http://xiaomi.eu/community/threads/problem-after-the-replacement-of-the-display-proximity-sensor-camera-focus.26077/#post-237579

Good that we is able to communicate. I had a problem with the status LED. I think you have a similar problem. The screen I bought has a black paint on the bottom. This painting would not let the LED brightness pass. The solution was to remove the paint with the end of a pin. I think it might...

My English is very bad, and did not quite understand what you said. But as you have two devices, and a proximity sensor works and the other does not. Swap screen. put your on your friend's device. so you find out if the problem is the sensor module or the screen. If the problem is in the module...

Remove ela do case, coloca a borracha sobre o módulo da câmera, ela vai encaixar certinho. Depois é só montar tudo novamente. Essa borracha tem de ficar recobrindo o módulo, e não solta no encaixe da tampa traseira. Testa lá e posta aqui o resultado

Problem after the replacement of the Display [Proximity sensor, camera focus]

The proximity sensor is not on the screen. is of the plate. On the screen are two holes that let the light in. These sometimes holes are too large and let in lots of light. Thus the sensor can not get a reading. The solution is to make a mask with electrical tape and soldering iron. It has a...

Hi! I see the Internet many people with the same problems after changing the Mi2S screen. I think nice if someone with more fluency in English compile this post with all the tips early on. would certainly be one of the main posts of hardware repairs

for the proximity sensor, see the video on page 1 For me, it worked

exactly. If you mount the device without removing the rubber camera module socket, the distance between the lens and the glass will be higher.