Recent content by ShotokanZH

The AX1800 you are currently using, is it updated to the latest firmware? Is it out there any global firmware for that router?

...it's a password field, it does not show anything, it's for added security...

Nothing at all happens on the secondary? If you wait a couple minutes and reconnect to the web page, does it still show the "welcome" page, still asking for the country?

The secondary router needs to be ~3m far for the first configuration, even if you are gonna use it in wired mesh configuration. (You can move it LATER) Also the secondary one needs to be in factory reset, with the welcome page still asking for the country :) Is that the situation?

Is the AX1800 in factory reset mode? If you do the first configuration nothing will work at all

Yeah, there surely will be some incompatibilities while you are using a non-global firmware, and I can't really say what might break. By the way, to update its firmware, once one will be available, just "unmesh" it, configure it once, upgrade it, re-factory reset it and re-mesh it via the...

Supposing that the ax1800 is using a global software too I'd say that I think you are receiving cached infos, clean the cache or access the page via anonymous browsing and retry :) the mesh one should be set in uk too!

Hey! I think that I have read somewhere that those are actually used by wireless mesh data sync, that's why you cannot use those channels :) I can see if those are still usable in ethernet mesh in case!

Sorry i forgot the -r: pip install -r requirements.txt

Just download the git repository in a folder (c:\seb\temp is ok) open a cmd, move to the c:\seb\temp (cd c:\seb\temp) and run python -m pip install requirements.txt python addmesh.py

Just download and install python version 3.7 or higher https://www.python.org/downloads/ And then you run the two commands that I have reported in GitHub, and you are good to go :)

Glad that it helped! :)

I have not tested with that specific device but it seems so :)

You are welcome! :)

Hi @atx90 , as promised I updated the script :)