Search results

My question before you have this problem did you have any problem? How do you think you got this problem? Did you do any system repairs before that?

I hope is ok.

If I turn the pedal and hold the gas, the engine should run.

Is the throttle cable intact? Is the gas connector good? Check if water has not entered the connector and it is oxidized.

We are lucky to have exactly the same bikes so I can test for faults. Because I can exchange devices and electronics with each other.

I have two Himo c26 bikes and they are two years old. Both bikes have traveled about 10,000 km in total. At most, we had a problem with the rain a few times, and water went into the brake controller. So far we have solved it with WD40 that we injected into the brake electronics.

Is it solved or not working?

Check the connector from the display. Unplug it and see if water got into it. Check if the contacts are not oxidized. It's also possible that water got into your display.

Turn off the battery. Take the battery out of the case. This is how you reset the electronics. Wait for 1 minute and then put the battery back in the case.

Himo z 20 and Himo c 26 they have the same screen and the same program. see the settings here:

If you just click the + key, the power changes. If you hold the + key for 3 seconds, the light turns on.

P = parking (pause) If the + key works, it should switch from eco to mid to high power. If the key- works, it should switch from high to mid to eco power. Do you have the battery set to 48v? Is the battery charged?

How old is the bike.

Hi Frano when you hold down the + key. Does the light come on? when you hold down the - key. Does it turns out P?

Hello, try blowing or spraying with wd40 or something similar based on oil or petroleum into the holes where the brake wires go through. Water/rain must have gotten into your brake electronics. All the best.

I am adding more pictures.

The electric motor is working. When testing, the 30H error no longer appeared. I did additional testing, turned off the display, braked with the brakes and turned on the display at the same time. It showed me error 25H. When I released the brakes, the error disappeared. Error 25H is...

Hi all, I had a 30H error on my e-bike (Himo c26). The display showed a 30H error, I could not turn on the light, although the display showed that it was on. Also, the electric motor did not work. The battery was 100% full. I disconnected all the cables except for the display and the...