Dual Sim And Sd At Same Time

[qbert]

I've managed to get dual sims and sd working at same time
Will post details when I get back to pc, this is based on a hack I saw on HUKD/xda for the honor 7.

Sent from my Redmi 3 using Tapatalk

 

[mezzi7]

tell us more about it

 

[qbert]

I will post pic of my sd /sim later, not easy now as not able with my job to use phone for very long at a time!
As I said, it's based entirely on the xda thread mentioned above, I take no credit other than being prepared to try in a different phone.

Sent from my Redmi 3 using Tapatalk

 

[qbert]

Seems I'm not the only one - the miui forum also has someone who's done it.
I practised with an old sim and old sd but they wouldn't fit.

After asking "kunhandi" on HUKD (he'd done it for the honor 7) he recommend the sd to buy:
http://www.amazon.co.uk/gp/product/B0166RR86O
is what i used - 64gb version - it's very thin

To separate the metal of the sim from the plastic - i just held it very close to a hair dryer with tweezers so i dont get burnt,and the glue softens - the plastic just goes soft and can be peeled off - careful not to force to much - dont damage the sim!

Next i made a mistake - i sandpapered the sd to make it thinner - but it ruined the card - DON'T DO THIS! no need.
Next attempt - i gently sanded the sim - just to remove excess glue.

Now with a spot of super glue, carefully glue the metal of the sim to the sd, in the right spot - i held it tight for a few minutes to make it as flush as possible.

next i found the combo would fit in the phone fine but the phone didn't read the sd.. i cut a small piece of sticky tape (approx 1mm x 3mm) and stuck it on bottom of sd under where the contacts are as i think they were being pushed down too far by the sim - pushed this all in and it works!

Its snug but i can remove it easily.

 

[qbert]

Sent from my Redmi 3 using Tapatalk

 

[parfetto]

View attachment 11389

Sent from my Redmi 3 using Tapatalk

And redmi 3 have enough space to sim+Sd with no forcing the port?
Have we to past the SIM to SD?

Thats greate..haha

 

[qbert]

It's a tight fit I admit but no problem getting it in or out.
First attempt was too tight I didn't want to force too hard...
Superglue the bare metal from sim, no need to cut the metal

Sent from my Redmi 3 using Tapatalk

 

[ZoXoR]

Nice hack!

Sent from my Redmi Note 3 using Tapatalk

 

[Piercarlo]

Good morning to All,
I had just prepare the dual sim in SD but not work...in any case to insert the metalplate is very hard and is not thin

 

[qbert]

Did you ensure sim was nice and thin, sand the glue off gently?
Also sd card have variable thickness

Sent from my Redmi Note 2 using Tapatalk

 

[haris Pao]

Hi
Does anyone else managed to make sd and sim at the same time?

 

[hdjack]

Thanks for your guide. I will try it